Configuration Worksheet

Use this worksheet and the chart below to prepare your Internet account information for Aplio/Phone configuration.

All configuration for the Aplio/Phone is done via the telephone keypad. Before starting, fill in your ISP phone number, user name and password and convert them to the codes shown below. Remember, if your user name or password contains only numbers, you do not need to convert it into codes or press the key before entering it into your Aplio/Phone configuration.

For example, your user name Jsmith98. Fill in the following:

Note that you start with the key to indicate to the Aplio/Phone that you will be entering the two-digit codes and you finish with a . Enter:
               

Now, pick up your telephone receiver and press the button twice in quick succession. Listen to the Main Options menu.

The first option you hear is "To enter your Internet access phone number, dial 1." Press , then enter the ISP phone number as you would normally dial it from your telephone.

1. ISP Phone Number

(Use prefix if necessary, i.e. 9)

After you enter the phone number (and to finish) the voice prompt will be recite it back to you. If it is correct, press to confirm and return to the Main Options menu. If it is not correct, press to re-enter it. If you need to hear it again, press .

Back at the Main Options menu, press to enter your user name. Remember to start by pressing key if your username contains even one character that is not a number.

2. User Name

 

When you press the key, the voice prompt will recite the user name you have entered. If it is correct, press to confirm it and return to the Main Options menu. If it is not correct, press to re-enter it. If you need to hear it again, press .

Back at the Main Options menu, press to enter your password.

3. Password

 

When you press the key, the voice prompt will recite the password you have entered. If it is correct, press to confirm it and return to the Main Options menu. If it is not correct, press to re-enter it. If you need to hear it again, press .

If your Internet access type is type 1 (the default) then you are done!

If you need to change your Internet access type, press at the Main Options menu. Enter your Internet access type, followed by the pound key.

4. Internet Access Type

When you press the key, the voice prompt will recite the Internet access type you have entered. If it is correct, press to confirm it and return to the Main Options menu. If it was not correct, press to re-enter it. If you need to hear it again, press .

Remember to conduct a test to make sure your configuration is correct.

Pick up the receiver, listen for the dial tone and press twice. While listening to the Main Menu options, press the button to begin a self-test.

The voice prompt will tell you to hang up.

DO NOT HANG UP UNTIL PROMPTED TO DO SO.

In about a minute your telephone will ring. When you answer it, the voice prompt will tell you "Test successful." After the test is completed, simply hang up.

If the test was unsuccessful, the voice prompt will give you an error message. Verify that you entered your Internet account information correctly. See Problems and Solutions, for further information on error messages. If you continue to experience problems, contact Aplio support.